Yamaha Battery Chargers

This page lists various replacement chargers for Yamaha battery chargers by model number, with the appropriate connector. Click on our replacement model listed after your OEM part number.

36 Volt Yamaha Chargers

OEM Number	OEM Amps	Connector	Our Eagle Unit
JN4-H2107-00	20,21	Crowsfoot	36 Volt 25 Amp
JN4-42107-00-00	25	Gray SB50	36 Volt 25 Amp
JN4-H2107-00-00	25	Gray SB50	36 Volt 25 Amp

48 Volt Yamaha Chargers

OEM Number	OEM Amps	Connector	Our Eagle Unit
MAC-SCR48-17-17	20,21	Yamaha MAC	48 Volt 18 Amp

Typical charger connectors available on the above chargers


EZGO™ 1996 and later	Club Car™ 1995 and later	Yamaha MAC connector



Crowsfoot	Anderson SB50/SB175 - Gray	Anderson SB50/SB175 - Red

Dual Pro Yamaha Battery Chargers

The Eagle industrial cart battery chargers by Dual Pro are heavy duty, microprocessor controlled, temperature compensating, thermally protected chargers, encased in a powder coated aluminum case. They can be portable or bench top chargers, with a padded handle. They are the basis of the Yamaha replacement battery chargers that we have available, and come with a couple of connectors to deal with the types of industrial carts made by Club Car. There is a 2 pin connector specifically for Yamaha, an Anderson SB50 in gray, and a crowsfoot connector.

We offer an 18 and 25 amp output range, for 36 volt to 48 volt Yamaha carts. The higher range (18 and 25 amp) is appropriate for a heavily used cart, either in hours per day or days per week. Running down to the mailbox, or out to the barn a time or two is moderate use. Running around the warehouse all day long, or 18 holes of golf would be heavy use. The point is to be sure the batteries are fully charged routinely, as partially charged batteries are subject to sulphation, which can be a problem over time.

The Dual Pro Eagle series combine the reliability of a heavy duty transformer, with a microprocessor controller, for long term performance and proper battery management. With temperature compensation and computer control, a quicker, more efficient charge cycle results in complete battery charge, better battery life, and less water loss in flooded batteries, which industrial cart battery chargers are frequently used on. They are safe for the sealed lead acid batteries as well. The Eagle model goes into a float mode when the charge is complete, for long term battery maintenance. The LED array on the charger case indicates status of the battery. This feature allows the charger to be left connected to the cart basically indefinitely, which works well for occasionally used carts or carts at a seasonal home or cabin. This prevents the internal discharge any lead acid battery experiences from forming hardened sulphation, which diminishes run time (capacity), even to the point of total failure. Some of the old chargers with timers or simple transformers could not be left on in this fashion, so frequently they are left disconnected from the cart when the cart would be left for a long time, shortening battery life, and diminishing run capacity. This feature alone is worth the cost of an upgraded charger.

The Eagle battery chargers are made in the US, and feature a 3 year warranty. They are suitable for medium to heavy use in 36 and 48 volt Yamaha carts, personnel carriers, tow carts, cargo carts, and other industrial equipment.

So, take a look at our Yamaha cart charger offerings, and call our tech line if you have any questions, or a special application. We only carry quality, reliable products that will do the job if properly selected.

Be sure to check out our Tutorials!

Home | Yamaha Battery chargers